The retired couple was excited at the possibility of getting help replacing their water heater. They admitted the old unit was working, but didn't seem to think it was providing as much hot water as it once did. With just the two of them, there was not a huge demand for gallons and gallons of hot water like there would be with a large family.

4) You will need to have on hand faucet repair tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.

To find a plumber, all one has to do is flip and run through the Yellow Pages or do a search on the Internet. From there you will see loads of plumber whom are advertising to get your job. The next thing you should do as a consumer is to take remember that there some plumbers whom advertise 2 different ads in the same place. Thus it is important to not water line repair make a rush decision. Look through the list of plumbers available and call a few (minimum of 3).



One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.

Getting advice from someone who has not made any money online is like asking a plumber to shoe a horse when they have never done so. Why in the world would you do this?

A broken water supply line can cause water to spurt from the line connecting the toilet to the main water valve. The first step to repair this leak is to shut off the water line repair supply valve. This will stop the flow of water to the toilet. Next, flush the toilet to remove the water from the bowl and hold down the handle until it is completely empty.

If you do in fact choose to replace it, there is a good chance that you have an Aqua Magic IV which is no longer produced and has been replaced with the new Aqua Magic V. If you are replacing your toilet and have the Thetford Aqua Magic IV, there are other options such as the Thetford Aqua Magic Style Plus or Thetford Bravura Toilet as well as choices from the Sealand line of toilets. You will have to choose whether you want a hand or foot flush, and whether you want to stay with plastic or upgrade to china. You will also have the choice of adding a water saver. Regardless of which choice you make you will most likely be happy with the quality and dependability of any product available.

Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.